To set up multicast on your Yealink phone: NOTE: Yealink T27 models the DND Softkey remains visible on the phone, but it is disabled so pressing it will not activate DND mode. (add the line to the "Options found in the MAC config" section) Save and Apply settings then reboot the phones.
To the Yealink Phone Configuration Template found in PBX Setup -> Phone Global. To Remove/Disable the DND Softkey on Yealink Phones: HTTP for remote extensions(also requires username and password from PBX Setup > Phone Global > Phone HTTP Download), and TFTP for local(local does not require a username and password. In base GUI enter in the provisioning URL.Set the extension Phone Type in the pbx to Yealink Generic.Porvisioning a Yealink DECT phone is the same as a regular phone, plus a few setps.
When using the Quick Setup Utility with remote phones the correct provisioning URL syntax Provisioning a Yealink DECT phone.Use this in conjunction with the quick setup utility NOTE: You can use the Yealink Generic phone type for provisioning a single extension to Yealink DECT Wireless phones W52P & W56P, additional extensions must be manually added. NOTE: All Yealink conference phones can use the CP860 phone type for provisioning The phone's screen should change to indicate that it is updating its config, and will then register if successful. Click Confirm at the bottom of the page.If the phone is remote: Set the username to admin, and the password to (Password is found under PBX Setup > Phone Global > Phone HTTP Download).If the phone is remote: Set server URL to.If the phone is local: Set Server URL to TFTP:///.Log into the GUI interface of phone via its IP Address (user: admin/pass:admin).Once the phones are assigned to extensions they can now be provisioned, either manually or if the phones are on the same LAN as the PBX the Quick Setup utility can be used. The coloring is merely cosmetic and will not affect the operation of the phone. ►Yealink phones shown in the Auto Discovery section will not show up colored green even though they may well be assigned and using the PBX. This will automate the process of entering the Yealink phone’s MAC address into each extensions Phone MAC field in it’s advanced settings section. Check the box next to each Yealink phone you are assigning. Select the extension you would like to assign to the Yealink phone(s) from the drop down list.Ģ. Click the “Auto-Discovery” tab at the top, and then click “Auto-Discovery (scan network)”ġ. SAVE CHANGES then APPLY CHANGES.Īuto Discovery - If the phones are on the same LAN as the PBX you can use Auto Discovery. Manual – Navigate to Destinations -> Extensions -> Edit Extension -> Advanced and enter the MAC address of the phone into the “Phone MAC:” field. You must assign a phone to an extension either manually or using Auto-Discovery: If it is running, it will say "Listening" on that page. You can restart it by going to the commands tab and hitting start, if it has stopped. The Yealink discovery function will run for about 10 minutes before shutting itself back off.
Phones that have been previously provisioned will NOT respond to configure or restart commands from this process. This only works for FACTORY DEFAULTED Yealink phones. Starting in version 6.0.5, we have added the ability to configure and restart Yealink phones from the autodiscovery section of the pbx, eliminating much of the process previously needed to set these phones up.ġ) Under Destinations=>Autodiscovery, after scanning the network, go to the commands tab and click the Yealink Detect link:ģ) In the list of phones discovered, you can now check the boxes, and assign, configure, and restart them as if they were IPitomy HD phones, using the buttons at the top of the page.
0 kommentar(er)
